Introduction
This guide will show you how to switch on the environmental control at the Nikon Spinning Disk.
-
-
We advise you to start heating up the temperature at least 30 minutes in advance. Make sure that the incubation box is fully closed while heating.
-
Switch on the enviromental control on the right side of the table
-
Switch on the Okolab touch screen - hold for few seconds.
-
-
-
Check if you have enough water in the humidifier.
-
If not, fill that from the top.
-
There is a bottle of MiliQ on the wall.
-
If you see, there is almost no water left in the bottle, please let the ZMB staff know!
-
Check that the humidifier is connected to the live cell chamber
-
-
-
Open the main valve of the CO2 bottle
-
Open the small valve of the CO2 bottle
-
Open the N2 valve, if needed.
-
-
-
Monitor CO2 level and temperature on the touch screen
-
Once the level is stable the orange dot will turn green
-
