Introduction
Here is shown how one can set up Z-stack imaging with LasX.
-
-
Go to the image tab and activate the Z tab by clicking on the Z.
-
Go to the Z-stack tab.
-
Define the upper and lower limit of the Z-stack
-
Shift the focus to the upper position with the Z-controller.
-
Click on "Begin" to save the current Z-position as the upper limit.
-
Shift the focus to the lower position with the Z-controller
-
Click on "End" to save the current Z-position as the lower limit.
-
The "Begin" and "End" button turn red, if a values is saved.
-
-
-
If you shift this slider to the right, you zoom in to the representation of the Z-stack.
-
This plane shows the current position of the stage in Z.
-
In this part the Number of Z-steps can be adjusted either manually, by distance or optimized for the current objective.
-
Team
