Introduction
For acquisition of large data sets or long term experiments it is recommended that you use the available X: (cache) drive. By doing so acquisition and saving is not limited by the network speed. Transfer of the files can be initiated through our Data Mover solution.
-
-
Before you start a "Scan", you will be asked for the storage location. Please make sure you save on "DataMover(X:)".
-
To achieve optimal performance/throughput it is always recommend to save to the X network drive. Saving directly to the files.core.uzh.ch file server is possible but not recommended. USB drives are also blocked.
-
Once you are done, please remove your sample and clean the microscope appropriately.
-
-
-
Do this step after the Software is closed.
-
This step can be done by launching Citrix Workspace directly on the instrument computer but also from everywhere else where you can access Citrix (Citrix guides).
-
Open Citrix Workspace and log on.
-
Select and launch the application "CORE Datamover" (the first start of the application can take up to 3 minutes)
-
Select the desired Datamover, in this case "GE InCell"
-
Click "Request".
-
You will get a confirmation that your request has been created. Your transfer job will be queued within 15 minutes.
-
If you do not receive an email after your request or if you need further support, please contact us at it@zmb.uzh.ch
-
